One question...

Theme: Symbol, component in schematic

Component name and -value: How can I fade them in and out?
How can I select single elements of a symbol? E. g. if I just want to move the name of a symbol.
Where are the +/- power supply connections of an IC? (Vcc, Vdd, Vss or GND...)
How can I mirror or rotate a component symbol?
How can I change fonts for symbol names only (height, weight, fatness)?
Which is best practise to search and find a component in TARGET?
How do I flip a component to the bottom side (soldering side)?
How do I handle a connected component that is not mounted on the PCB?
How can I fade out the handle cross?
Replace components: Why get component symbols twisted sometimes?
How do I get components onto my PCB that have been later added in the schematic?
Can I define the assembly side for the component already in the schematic?
How can I create a new component myself, e.g. also with several symbols (gates)?
Names of connectors should have the prefix X, not J. How to set this?
How can I move a finished circuit section to another schematic page?
How can I insert the Ohm-Character to the component value of a resistor (capital omega)?
How can I create a component that displays a custom property in the symbol? E.g. the drain-source voltage?
Why is there an "a" at the end of my component name? The component has only one "gate"?
The components on the first page should start with 100, those on the second with 200, etc....

Ask a question:

Ing.-Buero FRIEDRICH Privacy PolicyImpressum