Theme: Isolation milling
My GND pads are not being properly routed free, what do I need to do?
If your isolation channel (=aura) in a ground plane is as wide as the working width of your stylus (e.g. 0.3 mm), then TARGET does not take it so exactly with the separations in the same signal (e.g. GND pad <> GND ground plane). Therefore please increase the width of the isolation channels minimally:
(Fig. 1: Enlarge insulation channels to 0.31 mm).
To do this, type [Ctrl] + [a] in the board view to select all. Then type [e] for Edit and set all auras to 0.31 mm as in the dialog in Fig. 1. Alternatively, of course, you can also reduce the working width of the stylus cutter to e.g. 0.29 mm:
(Fig. 2: Reducing the working width of the stylus 2.9 mm)
